A031 connection via USB

Quark-elec AIS receiver and NMEA MUX products questions

A031 connection via USB

Postby Paul Clark » Fri Sep 01, 2017 1:52 pm

As the image shows, this set up on Hyperterminal taken from your manual is not working. Any suggestions?
Image 2.jpg
Image 2.jpg (30.42 KiB) Viewed 208 times
Image 1.png
Image 1.png (48.24 KiB) Viewed 208 times
Paul Clark
Posts: 14
Joined: Tue Jul 04, 2017 9:06 am

Re: A031 connection via USB

Postby admin » Fri Sep 01, 2017 1:59 pm

The configuration GUI is talking to A031(as your image shows, it has 'connected' so the output port cannot talk to Hyperterminal at the same time. The correct way you should do is closing GUI and Hyperterminal(for old Windows system, you maybe need plug out and plug in A031 again) and run Hyperterminal again, then you should see the messages come out.
Hope you can sort this issue through above way.
User avatar
Site Admin
Posts: 340
Joined: Tue May 13, 2014 2:50 pm

Return to Marine Electronics(AIS/NMEA MUX)

Who is online

Users browsing this forum: No registered users and 1 guest