Quark-elec NMEA Marine electronics › Forums › Remote Control Solution/Products › QK-G022 – latch more than one relay at the same time?
- This topic is empty.
-
AuthorPosts
-
16/11/2018 at 8:41 am #13489Anonymous
Good morning. We are using the ONOFFRXXXX# command to trigger relay one to latch for the required time in seconds.
Question:
Is there a command that can latch all three relays (or at least two) at the same time? Do you need to craft the command in a specific way?
I have tried ONOFFR0XXX# and ONOFFR4XXX# (thinking that perhaps 0 or 4 may represent all relays, but this doesn’t work)
Regards
16/11/2018 at 10:42 am #14215Hello Sadly there is not a command that can operate all the relays at once. you would be able to set a daily timer for relays 1 and 2 which could go off together. however this wouldn’t work for relay 3 because it doesn’t have a timer facility. sorry i couldn’t any solution.
Best regards
-
AuthorPosts
- You must be logged in to reply to this topic.