Quark-elec NMEA Marine electronics › Forums › Marine Electronics(AIS/NMEA Multiplexer) › A034 NMEA-0183 and NMEA 2000 Data Translation

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • 07/01/2021 at 5:54 pm #13791
    Anonymous

      Is there an article or table or chart that describes which NMEA-0183 SENTENCES can be translated to which NMEA-2000 PARAMETER GROUPS ( and vice versa) by the A034 device?

      07/01/2021 at 9:39 pm #15073
      Quark Elec

        Chapter 3.6 in the manual show that.https://quark-elec.com/doc/QK-A034_manual.pdf“.
        Thanks.

        07/01/2021 at 10:40 pm #15074
        Anonymous

          Thanks for the quick reply.

          I see in Section 3.6 the list of conversions of NMEA-0183 sentences to NMEA-2000 Parameter Grops does not show sentences DSC and DSE.

          The sentences DSC and DSE would typically be sent from a DSC radio.

          Is the omission of DSC and DSE an error in the table?

          Or are DSC and DSE omitted for a particular reason?

          Is there a protocol problem or conflict that prevents the inclusion of DSC and DSE in the lexicon of translations possible?

          03/06/2021 at 4:13 pm #16549
          Quark Elec

            Hi, Thanks for the comments. AAM,ABM,APB HSC,VDR,DSC,DSE will be supported soon.

            15/11/2021 at 11:23 am #17709
            Quark Elec

              Contact us please. We have released Beta version firmware which support above sentences.

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.
            Cart